B367 Gr. C-2 Titanium Y-strainer

B367 Gr. C-2 Y-shaped strainer has the characteristics of advanced structure, low resistance, and convenient discharge. The Y-type filter is suitable for media such as water, oil, and gas. The general water supply network is 18-30 mesh, the ventilation network is 10-100 mesh, and the oil supply network is 100-480 mesh. The basket filter mainly consists of a connecting pipe, a main pipe, a filter blue, a flange, a flange cover, and fasteners. When the liquid enters the filter blue through the main pipe, solid impurity particles are blocked inside the filter blue, and clean fluid is discharged through the filter blue and through the outlet of the filter.

Y-shaped filter is a small device that removes small amounts of solid particles from liquids, which can protect the normal operation of the equipment. When the fluid enters the filter cartridge with a certain specification of filter screen, its impurities are blocked, and the clean filtrate is discharged from the filter outlet. When cleaning is needed, simply remove the detachable filter cartridge, process it, and reinstall it. Therefore, maintenance is extremely convenient. The Y-shaped filter, also known as a dirt remover or filter valve, is an indispensable device in the pipeline system for conveying media. Its function is to filter mechanical impurities in the medium, and it can filter rust, sand particles, small amounts of solid particles in the liquid in sewage to protect the accessories on the equipment pipeline from wear and blockage, and to protect the normal operation of the equipment.

Y-shaped filter is a Y-shaped filter, with one end allowing water and other fluid to pass through and the other end settling waste and impurities. It is usually installed at the inlet of a pressure reducing valve, relief valve, constant water level valve or other equipment. Its function is to remove impurities from the water and protect the normal operation of the valve and equipment. The water to be treated by the filter enters the body through the inlet, and impurities in the water deposit on the stainless steel filter screen, resulting in a pressure difference. By monitoring the pressure difference changes at the inlet and outlet through a pressure difference switch, when the pressure difference reaches the set value, the electronic controller sends signals to the hydraulic control valve and drive the motor, triggering the following actions: the motor drives the brush to rotate to clean the filter element, while the control valve opens for drainage. The entire cleaning process only lasts for a few seconds. When the cleaning is completed, the control valve is closed, the motor stops rotating, and the system returns to its initial state, Start the next filtering process. After the installation of the equipment, technicians carry out debugging, set the filtration time and cleaning conversion time. The water to be treated enters the machine body through the inlet, and the filter begins to work normally